Leaderboard

So while at PSP last Friday before the plant tours began, we all mull around in the Heritage guitar showroom looking at all the beautiful works of art hanging on the walls. Hanging in the corner all lonely by itself was a 155 Millennium in trans Wine with gold hardware. The Guitar was built in 2016 and apparently taken to a few trade shows and then put up in a case somewhere as it never got sold. Mike Ortiz found it in the back in a case and took it out hung it up in the showroom, and when I laid eyes on it, I knew it had to be mine. I worked out the details with Mike and he said they would go over the guitar and then ship it to me this week because I was driving back to Florida. Well, I received a communication from him this morning that the Guitar had a little bit of finish checking on the top that he was unaware of and so was I. That doesn’t bother me that much but it was able to gain an additional discount on the guitar and today went through a PLEKING job and a buffing, and he’s putting a new bridge and stop tail on it with a full set up. These guys at Heritage, both Pete Farmer and Mike Ortiz are the real deal and the fact that they went so far above and beyond for me on this guitar is a true testimonial. It’s things like this that keep me very loyal to the brand. I will post more pics soon as I receive it.

Nice semi hollow there... but would still like to seek some of the advise off from Faber bridge users out there... Cause Heritage uses the tailpiece stud well with thread size SAE 5/16-24 but Faber tailpiece screw post adopt M8 x 1.25 non SAE thread.... did some reading if am not wrong these size can fit but it be kinda loose .... Do you guys also swap out the tailpiece stud well to Faber matching type or just retain the stock Heritage SAE 5/16-24 stud well?